Tennsco Electronic Workbench - Manual

DESCRIPTION
Tennsco electronic workbenches are designed for
electronic assembly, testing, product development and
other uses where access to multiple power outlets is
important. The workbench can use either 30" x 60", 30" x
72" wood tops or 36" x 72" steel tops (see below). Workbench
legs and frames are box formed for strength and rigidity.
Frame front panel has knockouts for four duplex receptacles
as well as a switch and circuit breakers (order optional wiring
kit separately). Removable cover behind receptacle panel
facilitates wiring and prevents contact with rear terminals.
Tennsco tops are available in a choice of two widths and
two depths and are pre-drilled for mounting to various
workbench bases.
Steel Benchtops (S) are constructed of smooth steel
surfaces, reinforced with channels at each end. There are
no exposed sharp edges or corners. A steel stringer is
included to provide extra rigidity.
Hard Maple Laminate Benchtops (W) are 1
3 ⁄
4
" thick
laminated solid hard maple with a smooth oil-seal natural finish.
Plastic Laminate Benchtops (P) are 1
5 ⁄
8
" thick with grey
linen, maintenance-free, high pressure non-conductive
plastic laminate over a compressed wood core with a
phenolic backer sheet.
Compressed Wood Benchtops (C) are 1
3 ⁄
4
" thick and
constructed of tempered hardboard top and bottom surfaces
laminated to a high density compressed wood core. A
smooth, sealed finish gives a durable, non-porous surface.
Available options are listed in the replacement parts list
included in these instructions.
SPECIFICATIONS
Overall Dimensions
All 3072 models .......................... 72"w x 30"d x 33 1 ⁄
2
"h
All 3672 models .......................... 72"w x 36"d x 33 1 ⁄
2
"h
Basic Construction
Steel Top
Top ..................................................12 gauge steel
Reinforcing Channels ......................14 gauge steel
Hard Maple Laminate Top
Top ..............................................Laminated Maple
Compressed Wood Top
Top ........ Hardboard with Compressed Wood Core
Plastic Laminate Top
Top ..............Laminated High Pressure Plastic with
Compressed Wood Core
Panel Legs .............................................16 gauge steel
Stringer ..................................................14 gauge steel
Wireway Cover ......................................20 gauge steel
Receptacle Panel...................................16 gauge steel
Back Panel.............................................16 gauge steel
Options Available:
Side and back rails Lower Shelf
Standard and electronic riser Stackable Drawer
GENERAL SAFETY INFORMATION
Some parts may have sharp edges. CARE must be taken
when handling various pieces to avoid injury. For safety,
wear a pair of work gloves when assembling or performing
any maintenance on workbench.
ASSEMBLY INSTRUCTIONS & PARTS MANUAL #1340397
ELECTRONIC WORKBENCH
Tennsco Corp., Dickson, TN 37056-1888 * (615) 446-8000
READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING
TO ASSEMBLE YOUR Tennsco ELECTRONIC WORKBENCH.
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE!