Tennsco LSS-361872 - Manual (Page 4)

REF. NUMBER DESCRIPTION PARTS NO. QTY.
A Upright Post EUR-36 8
B Shelf Support (18" wide) VDRS-1816 10
C Shelf Support (36" wide) VDRS-3616 10
D Particleboard Shelf PBV-3618 5
ORDER REPLACEMENT PARTS DIRECT FROM FACTORY
Please Provide the following information: Contact: STUR-D-STOR, P.O. Box 1888
•
Model Number Dickson, TN 37056-1888
•
Part Description and Number as Shown Above (615) 446-8000 (800) 251-8184
A B C D
Assembly as a Workbench/Shelf Unit
Tool required: Rubber Mallet or Hammer
Parts List
A. Follow steps one through
six on the inside of this
assembly sheet. B. Instead of stacking the
uprights on top of each other,
as shown in step seven inside
this sheet, place four shelf
supports in the top two
keyhole slots, being sure that
the flat edge of each shelf
support is facing up as
described in earlier steps.
C. Now, build the second unit in the same
manner as you did the first unit, except this
one with only two levels. Place the top
level in the top two keyhole slots, and the
second level at whatever
height you prefer (see
illustration).
D. Insert one
particleboard
shelf at each of
the five shelf levels, as
described in step 11 inside
this sheet. Then, place the two
units together, or use seperately as desired. Your
Stur-D-Stor Shelving System is now ready for use.