Tennsco LSS-361872 - Manual (Page 2)

Step By Step Installation Instructions
Tool required: Rubber Mallet or Hammer
1. Remove all parts from carton and
check against the parts list on back
cover for any missing parts.
3. Place a second
18" wide upright
halfway up the
upright assembly
as shown.
2. Connect two upright posts (Ref. A) with a
18" wide shelf support (Ref. B) by
inserting shelf support rivets into the
bottom two keyhole slots of each upright.
Use a rubber mallet to seat the upright
securely in the keyhole slots.
NOTE: Make sure that the narrow
end of the keyhole slots are pointing
downward, and that the flat edge of
the shelf support is facing up, as
shown in exploded view below.
4. Repeat steps 2 and 3 to
prepare a second set of
uprights, as shown. You should
now have two upright end
assemblies.
A
B
A
5. Place the two end
assemblies about 36"
apart, with the angled corners
facing outward. Connect two 36"
shelf supports (Ref. C) between the
two assemblies, one on each side,
as shown. Be sure to use the two
keyhole slots nearest the floor, as
before.
NOTE: As in step two, make sure the flat edge of the
shelf supports are facing upward. If you have done this
correctly, there should now be a flat surface around all
four edges on which to lay the bottom particleboard
shelf. If any edge has an upward-facing angled edge, the
upright has been inserted upside-down.
C
C