Tennsco J2478A - Manual (Page 2)

Insert bolts
in holes
Step By Step Cabinet Assembly Instructions
(APPROXIMATE ASSEMBLY TIME: 2 people, 25 to 45 minutes)
TOOLS REQUIRED: A free 11/32" nutdriver is included with each Tennsco cabinet. You will also need a flathead screwdriver and a hammer.
2. Place back panels on a smooth surface,
making sure that the flanges of both
panels are facing up. Overlap
the right panel over the left
panel. After aligning
the holes, bolt the
two panels tightly
together with seven bolts
and nuts.
Right
side overlaps
the left
1. Before beginning assembly, compare the parts you have
received against the parts list on the back cover to ensure that
you have all the necessary pieces.
3. Attach the left side to the back by
placing flange (A) around the
back and bolting tightly
together with seven
bolts and nuts.
Be sure that
all shelf
adjustment
strips (B) point
in the same
direction.
All lances point UP on
both back and side.
B
Flange goes
under back.
A
B
6. Attach right side to back in the same manner as you did in step 3,
making sure that the side flange is
around the back and the top
flange is over the top. As
before, be sure that all
shelf adjustment strips
point in the
same direct-
ion. Attach
three
bolts and
nuts across the top,
and seven bolts and nuts
down the side panel.
5. Attach the
top to the back and left side by
inserting the bolt heads (which
you installed in step 4) into the
large end of the keyhole slots,
then sliding them securely into
the smaller end. Be sure that the
back flange on the top overlaps on the
outside of the back, while the flange on the
side panel fits over the left edge of the cabinet top as illustrated above.
Attach four bolts and nuts through the holes in the back, and three
bolts and nuts down each side. Tighten all bolts and nuts securely,
including the four bolt heads which you loosely attached in step 4.
7. Insert bolts into the outside holes on the sill
(two on each end). Attach the nuts, but
do not tighten. Place the sill
between the sides at
the front of the
cabinet, insert-
ing the loose bolt
heads into the
two keyhole slots
on each side. Make
sure the bolt heads are
fully pulled down into the
bottom of the keyhole slots, as
shown at right. Securely tighten the four
bolt heads.
9. Using two people, set unit upright
and insert the remaining shelves
at the desired levels. Be sure that
the edge with no slots is toward
the cabinet front. The slots on the
other three sides will fit over the
lances on the cabinet walls,
which will hold the shelf in place.
It is helpful to have two people
present to insert the shelves to
be sure that all lances are
engaged.
This flange goes
under the back.
This flange
goes over
the top.
No flanges visible
from the inside.
Insert shelf into
the bottom notches
on back AND sides.
8. Place a shelf into the
bottom lances, located
on
the back and
sides of the unit.
The flange on
the sill will be
just in front of
the shelf.
Inset A Inset B 4. Insert bolts into the outside holes on
the header portion of the top (two on
each end as shown in Inset A).
Attach the nuts, but do not tighten;
the bolt heads will later be
inserted into the keyhole
slots of the sides,
as shown in
Inset B.
Bolt heads
insert into
keyhole
slots.
Properly
Inserted
Improperly
Inserted