Tennsco 1471 - Manual (Page 3)

2. Turn the handle to
the open position,
and place the
locking cam (Ref.
No. 13) over the
square shank of
the door handle.
The latch must be
facing downward
as shown.
13. Attach the right door (Ref. No.
10) to the unit in the same
way you attached the left
door.
1. Place the locking
handle (Ref. No. 12)
on the right hand
door and fasten with
two slotted bolts with
lockwashers.
Handle/Locking System Installation Instructions
4. Place the locking cam
retainer (Ref. No. 14)
over the square
shank of the door
handle. Tap on the
edges of the cam
retainer with a
hammer until retainer
sits firmly against the
locking cam.
3. With the handle still in the open
position, hook the locking bars (Ref.
No. 11) to the locking cam (see "A" at
left). Then, hold the lock bars in
position while sliding the nylon lock
bar guide inserts (Ref. No. 15) over
the lock bar ends and through
the door slots (see "B" at left).
A
B
B
14. Instructions for attaching
the handle and locking
mechanism are given at
right.
9. Place the bottom (Ref. No. 7) in the bottom
lances of the shelf adjustment
strips. The
flange with
two holes
should
face the
front, and
it should
hang over the
sill. Bolt to the
sill with two bolts and nuts.
10. Turn the unit on its side. Then,
attach the top (Ref. No. 8) by
sliding it under the sides and
header, with the flange
hanging over the back. Secure
with 14 bolts and nuts (three
along each side, four in the
back, and four along the front).
12. Attach the left door (Ref. No.
9) to the unit by placing the
door on the hinges, aligning the
holes, and using a hammer
to tap the hinge pins (Ref.
No. 16) into place
with the
side of a
screwdriver.
11. Set the unit upright and attach a coat rod bracket
(Ref. No. 18) beneath the left side of the cabinet
shelf by inserting one bolt through the hole in the
left edge of the shelf. Secure with
a nut. Attach the right bracket in
the same way. Then,
slide the coat rod
(Ref. No. 17) through
holes in the brackets
(Inset E.)
Inset E
Mount
brackets
by
attaching
here
with
one
bolt
and
nut.
Top
goes
under
side flanges
Top tucks under
front flange
Insert shelf into
bottom lances.
Two
hole
s m
ust
be in
fro
nt.