Star Lights Revolution T5-12 - Manual (Page 4)

- 4 -
6. After locating the Ground wire (-), attach the
wire to the Wiring Harness as shown in Figure
8 using the wire nut provided. The REV T5
LED TUBE LIGHT™ contains polarity correcting
circuitry, so do not be concerned which of the (+)
or (-) connections the Harness wiring is connected
to.
7. After connecting the wiring harness connections
in Step 6 above, replace the Ballast Cover
taking care to be sure there are no sharp edges to
cut the Wiring Harness. Leave the end of the
harness protruding as shown in Figure 9.
8. With the harness that was left protruding in Step
7, plug the REV T5 LED TUBE LIGHT™
harness into the protruding plug as shown in Figure
10.
9. REV T5 LED TUBE LIGHT™ to the right
shown in Figure 11, fully installed and locked
into the fixture with the harness tucked in behind
the ballast cover. Replace the fixture lens and the
installation is complete.
Wire Connector
Figure 8 -
T5 Fluorescent Tube Fixture Showing the Negative (-)
Wire affixed to the Wiring Harness Provided with the Tube Light.
Ballast Cover Harness Plug
Figure 9 -
T5 Fluorescent Tube Fixture the end of the Harness
protruding from under the ballast cover
Harness & Plug
Figure 10 -
T5 Fluorescent Tube Fixture with the Harness &
Plug
Figure 11 -
T5 Fluorescent Tube Fixture with the Rev T5 LED
Tube Light fully installed