SnowEx SR-210 - Manual (Page 22)

© Trynex International 2009 L1600 1 — 22
Safety
Never exceed 45 m.p.h. when loaded spreader is attached to vehicle. Braking distances may be
increased and handling characteristics may be impaired at speeds above 45 m.p.h.
Never use wet materials, or materials with foreign debris with any of these spreaders. These units
are designed to handle dry, clean, free-flowing material. Note: Can not spread water softener salt.
Never leave material in hopper for long periods of time. Be aware that all ice melters are hygroscopic
and will attract atmospheric moisture and harden up.
Always inspect pins and latches whenever attaching or detaching spreader, and before traveling.
Inspect the unit periodically for defects. Parts that are broken, missing, or worn out must be replaced
immediately. The unit or any part of it can not be altered without prior written permission from the
manufacturer.
D 6548 D 6335 D 6544
Examples of warning decals to indicate operational awareness.
If your vehicle is equipped with a tow package, please refer to enclosed charts and diagram for
proper installation. Failure to follow these instructions will seriously damage the unit and or
the vehicle. Once installed and plugged in verify that the unit works before loading with
material. This will make it easier to diagnose any problems that may occur.
Any wiring should be done by a certified professional to prevent any damage to the vehicle’s
wiring or electronic systems.
Model # SR-110 / SR-210