Tools list – SnowEx VBR-400 User Manual

Page 2

Introduction

Have a question or need assistance?
SnowEx Customer Care

1-800-SALTERS
or (248) 586-3500

Monday through Friday 8:00 AM to 4:30 PM EST
Fax: (248) 691-8378
E-mail: [email protected]
Website: www.snowexproducts.com

This VBR-400 is designed to increase material flow on the SnowEx Super-Maxx 9800X when spreading low-flow materials such as moist salt
and sand-salt mix. This kit connects directly to the existing Control Module of the Spreader, integrating completely with the existing controls –
there is no need for additional switches.

CONTENTS

Installation Instructions

Installing the Vibrator ............................................................................................................................................................... 3 - 4

Wiring Installation .................................................................................................................................................................... 5 - 7

Parts Key ..................................................................................................................................................................................................... 8

Please read this Installation Guide carefully before installing. Pay particular attention to safety messages.
Refer to the Owner’s Manual of your Spreader for Operation, Maintenance and Troubleshooting information.

Remember, most accidents are preventable and caused by human error. Exercising of care and precautions
must be observed to prevent the possibility of injury to operator or others!

Before working with the spreader, secure all loose fitting clothing and unrestrained hair.

Always wear safety glasses with side shields when servicing spreader. Failure to do this could result in serious
injury to the eyes.

Never weld or grind on equipment without having a fire extinguisher available.

Park vehicle on level ground before servicing the spreader.

Follow all vehicle safety information.

Tools List

3/4” Wrench

Grinder

Spray Primer and Paint (optional)

Drill

3/8” Drill Bit

9/16” Wrench

9/16” Socket w/ Ratchet x2

Step Drill Bit [for 1-1/8 Hole]

5/16” Nut Runner

Flat Screwdriver (for prying)

1/2 Socket w/ Ratchet

7/16” Socket w/ Ratchet

3/8” Socket w/ Ratchet

Ratchet Extension

Eye Protection

Dielectric Grease

Tongue-and-Groove Pliers
(Channellocks).