5 measuring operation with the, Seca keyboard module, Measuring operation with the seca keyboard – Seca EMR Flash 101 User Manual
Page 17

Operation • 17
5.5
Measuring operation with the seca keyboard module
The seca keyboard module allows measured results to
be inserted directly at the cursor position in any target
software, e.g. a word-processing program or a PDMS,
which does not support common transmission proto-
cols (HL7, GDT).
Notice!
Software malfunction in measuring mode
Transmitted data are converted into keyboard
input, so in measuring mode, this may cause
the
seca 101
PC software or the target soft-
ware to behave unexpectedly.
►
Check at the start of measuring that the tar-
get software,
not
the
seca 101
PC software
is the active window.
►
When the seca keyboard module is activated,
never
press the
send to EMR
button.
►
If you are uncertain what kind of connection
has been set up between your target soft-
ware and the
seca 101
PC software, contact
your administrator.
NOTE:
The seca keyboard module is not available for
devices with an RS232 interface.
1. Check that the
seca 360° wireless
USB adapter 456
is inserted in a USB port of the
PC and that the LED on the USB adapter is red.
2. Ensure that all the measuring devices you have se-
lected in the
seca 101
measuring devices" on page 11) are selected.
NOTICE!
Incorrect measurement if wrong devices
selected
If the wrong devices are selected, measured
results may be assigned to the wrong patient or
measurements may not be received at all.
►
Use the name of each device to check you
have selected the right devices.
3. Perform the measurement(s) on the patient.
seca 101
PDMS