SANDPIPER M02 Metallic - Manual (Page 6)

Installation Instructions - Typical
The typical installation shown in Figure.1 is only a guide to
selecting and installing system components. Your installation
will depend on the type of fluid being pumped and your
application needs. To reduce the risk of serious bodily injury
and damage to property, never use fluids in this pump which
are not compatible with the wetted components. Contact your
local distributor or the manufacturer for system design
assistance & compatibility if necessary.
Mount the pump in an upright position. Failure to ensure an
upright position may result in loss of or poor priming
characteristics. Ensure the pump is securely mounted to avoid
movement and possible risk of bodily injury.
NOTE: Pressure Regulator (H) should be installed where air
supply could exceed 8.6 Bar (125 psi).
520-263-000 5/03 Model M02 Metallic Design Level 1 Page 5
Figure 1
Figure 2 VENTING EXHAUST AIR
AIR SUPPLY
B
A
C H
?
D
G
E
F
A - Main Air Line
B - Branch Air Line
C - Bleed Type Master
Air Valve
F - Suction Hose - c/w
Foot-valve & Strainer
G - Delivery Hose
H - Filter/Regulator/
Lubricator
Key
D - Discharge Port
E - Suction Port