SANDPIPER MSA2-C - Manual (Page 8)

Models MSA2 MSA2-B MSA2-C Page 6 msa2dl5sm-rev0614
IMPORTANT SAFETY
INFORMATION
RECYCLING
Many components of SANDPIPER ® AODD pumps are made
of recyclable materials (see chart on page 8 for material
specifications). We encourage pump users to recycle worn out parts
and pumps whenever possible, after any hazardous pumped fluids
are thoroughly flushed.
Pump complies with Directive 94/9/EC, EN13463-1
Equipment for use in Potentially Explosive Environments.
For reference to the directive certificates visit: www.warren-
rupp.com.
Pump complies with EN809 Pumping Direc-
tive, Directive 2006/42/EC Machinery, according to
Annex VIII.
I M2 c T5
II 2GD T5
II 2G c T5
II 3/2Gc T5
II 2Dc T100°c
This pump is pressurized
internally with air pressure
during operation. Always
make certain that all bolting
is in good condition and that
all of the correct bolting is
reinstalled during assembly.
WARNING
Before pump operation,
inspect all gasketed fasteners
for looseness caused by
gasket creep. Re-torque loose
fasteners to prevent leakage.
Follow recommended torques stated in this manual.
CAUTION
When used for toxic or
aggressive fluids, the pump
should always be flushed
clean prior to disassembly.
WARNING
Before maintenance or repair,
shut off the com-pressed air
line, bleed the pressure, and
disconnect the air line from
the pump. The discharge line
may be pressurized and must
be bled of its pressure.
WARNING
Before doing any main-
tenance on the pump,
be certain all pressure is
completely vented from the
pump, suction, discharge,
piping, and all other openings and connections.
Be certain the air supply is locked out or made
non-operational, so that it cannot be started while
work is being done on the pump. Be certain that
approved eye protection and protective clothing are
worn all times in the vicinity of the pump. Failure to
follow these recommendations may result in serious
injury or death.
WARNING
WARNING
Airborne particles and loud
noise hazards.
Wear ear and eye protection.
WARNING
In the event of diaphragm
rupture, pumped material
may enter the air end of the
pump, and be discharged into
the atmosphere. If pumping
a product which is hazardous or toxic, the air
exhaust must be piped to an appropriate area for
safe disposition.
Take action to prevent static
sparking. Fire or explosion
can result, especially when
handling flammable liquids.
The pump, piping, valves,
containers or other miscellaneous equipment
must be grounded. (See page 32)
WARNING
IMPORTANT
Read these safety warnings
and instructions in this
manual completely, before
installation and start-up
of the pump. It is the responsibility of the purchaser
to retain this manual for reference. Failure to comply
with the recommendations stated in this manual
will damage the pump, and void factory warranty.
Read these safety warnings
and instructions in this
manual completely, before
installation and start-up
of the pump. It is the responsibility of the purchaser
to retain this manual for reference. Failure to comply
with the recommendations stated in this manual
will damage the pump, and void factory warranty.
CAUTION
Pump not designed,
tested or certified to be
powered by compressed
natural gas. Powering
the pump with natural
gas will void the warranty.
WARNING
Use safe practices
when lifting
kg