RIKON Power Tools 51-200 - Manual (Page 8)

8
Warning: Applying the workpiece to the right side of
the disc could cause workpiece to fly up (kickback)
and result in an injury.
Please take note of the disc rotation (counter clock-
wise) and only work on the left side of the disc.
(See Fig. 08)
Applying the workpiece to the left side of the disc will
cause downward pressure against the table.
Operation
Bevel Sanding
The work table can be tilted from -45 to +45 degrees
for bevel sanding. Loosen the table lock knob and tilt
the worktable to desired angle as shown. Retighten
table lock knob. (See Fig. 09)
Warning: To avoid jamming the workpiece or fingers
between the table and sanding surface, the table
should repositioned on the table support to retain a
maximum of 1/16” distance between sanding surface
and table.
Sanding Small End Surfaces on the Sanding Disc
Note: Use of a miter gauge is recommended for this
operation.
Always move the work across left side of center on
the sanding disc face as shown. (See Fig. 10)
Warning: Applying the workpiece to the right side of
the disc could cause workpiece to fly up (kickback)
and result in an injury.
Fig. 08
Fig. 09
Fig. 10