RIKON Power Tools 51-200 - Manual (Page 6)

6
Assembly
Securing Sander Base Assembly to Workbench
The sander base must be secured before using.
Attach a large C-Clamp to each side of the sander
and the workbench. Or, permanently mount following
the instructions below:
1. Place the sander on the workbench in its final
operating location.
2. Place a pencil through the mounting holes of
the sander base and mark the hole locations on
workbench.
3. Remove sander and drill four 3/8” holes through the
workbench.
4. Align sander base over holes and secure using four
5/16” screws (or larger) and hex nuts.
(See Fig. 01)
Table Adjustments
The table stops have been pre-set at the factory.
Follow the steps below if adjustments are needed.
1. Loosen lock knob (Fig. 02) and move table
into the 90-degree position. Tighten lock knob and
place a square against the table and sander disc. The
square should rest flat against the table and the disc.
2. If adjustment is needed move the table so that it
rests 90 degrees from the table, and loosen the two
adjusting nuts (Fig. 03) on the stop bar and slide bar
left or right for the proper adjustment. Once the proper
adjustment is made tighten the two adjusting nuts on
the stop bar.
Fig. 03
Fig. 01
Fig. 02
Mounting Holes
Lock Knob
Adjusting Nuts