RIKON Power Tools 50-150 - Manual (Page 8)

8
Removal:
1. Remove and set aside mitre gauge.
2. Completely remove the disc-table adjustment
handles.
3. Tip table up and remove.
4. Sanding discs are adhered to the plate using a
“pressure-sensitive adhesive”. Remove sanding disc
from disc plate.
Installation:
5. Ensure disc-plate is clean.
6. Peel backing from new sanding disc.
7. Press new sanding disc firmly onto disc-plate.
Note: Hook & Loop sanding discs cannot be used with
this type of sander!
8. Replace the sanding table and handles that were
removed in step 2 (above).
Installing or Changing Accessories – Sanding
Belts
WARNING! Turn the power off and remove the plug
from the outlet before changing the accessories.
Removal:
1. Remove lock-knob and two Phillips screws;
2. Remove side cover.
3. Loosen tracking knob to release belt tension.
4. Remove belt from three wheels.
Installation:
5. Install new belt.
6. Replace side cover.
7. Before using, check belt tracking as described in
“Belt Tracking” section, and adjust as necessary.
Fig. 08
Fig. 09
Fig. 10