RIKON Power Tools 50-150 - Manual (Page 11)

11
General Usage and Operating Instructions
ON/OFF
The rocker ON/OFF power switch is located on the
top of the sander.
1. Press the side marked ON to turn the sander on.
2. Press the side marked OFF to turn the sander off.
Operating Instructions – Belt Sander Platen
The platen is a heavy steel support plate that is
positioned behind the sanding belt, rising from
the table level to a point several inches above the
table level. Its purpose is to support the work when
sanding. The platen should be adjusted so that it is
almost touching the back of the sanding belt. This can
be done by loosening the two hex screws that fasten
the bottom of the platen to the sander frame. If the
platen is out of alignment for some reason, loosen
these two screws, adjust the platen, and retighten the
two screws.
To remove the platen for operations such as
strapping, polishing or other special operations,
remove the two screws that fasten the bottom of the
platen to the frame, and remove the platen.
Mitre Gauge – Disc Sander
A mitre gauge is supplied with your sander, and can
be used on the disc table, as shown. The mitre gauge
head can be set anywhere up to 45º (right or left) by
loosening the lock-knob, setting the mitre gauge head
to the desired angle and retightening the lock-knob.
Maintenance
WARNING! Turn the power switch “OFF” and
disconnect the plug from the outlet prior to adjusting
or maintaining the sander. DO NOT attempt to repair
or maintain the electrical components of the motor.
Take the sander to a qualified service technician for
this type of maintenance.
General Usage and Maintenance
Maintenance Required Frequency
1. Check power cord Before each use.
2. Check sanding belts and discs for damage Before each use.
3. Check moving parts for alignment and binding issues Before each use.
4. Dress sanding surfaces As needed
5. Replace sanding belts or discs (see manual section for specifics) As needed.
6. Clean and vacuum dust from the motor housing and other sander parts As needed.
Service beyond recommended maintenance on these tools should only be performed by an authorized,
qualified technician.
On/Off Switch
belt support
Mitre Gauge