RIKON Power Tools 30-251 - Manual (Page 8)

B
A
Figure 7
Head Assembly
1. Place the locking shoe (part# 15B) in the recessed
pocket of the head. (Fig. 5)
2. Place the drill press head (A-Fig. 6) onto the
column (B-Fig. 6) as far as it will go.
3. Attach the 2 clamping levers (part# 30B) on the
drill press column guide (part# 18B). (Fig. 7)
Figure 5
Figure 6
Figure 8
Figure 9
8
Assistance is needed for this next
step.
NOTE:
clamping levers
A
B
locking lever
4. Align the drill press head (A-Fig. 8) with the
base of the drill press.
5. Tighten the drill press head (A-Fig. 8) to the
column (B-Fig. 8) by tightening the locking lever
(part# 30B) on the left side of the guide column
(part# 18B).
6. Attach the three feed handles (part# 35B) to the
hub (part# 36B). Fig. 9