RIKON Power Tools 30-251 - Manual (Page 3)

ALWAYS CHECK FOR DAMAGED PARTS.
Before initial or continual use of the tool, a guard or other part that is damaged should be checked to
assure that it will operate properly and perform its intended function. Check for alignment of moving
parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect
its operation. A guard or other damaged parts should immediately be properly repaired or replaced.
ALWAYS DISCONNECT TOOLS.
Disconnect tools before servicing and when changing accessories such as blades, bits, and cutters.
ALWAYS AVOID ACCIDENTAL STARTING.
Make sure switch is in “OFF” position before plugging in cord.
NEVER LEAVE TOOLS RUNNING UNATTENDED.
Special Safety Rules For Drill Press
SAVE THESE INSTRUCTIONS.
Refer to them often.
3
1. Do Not operate the Drill Press until it is
assembled and you have read the instructions.
2. Do not operate the Drill Press unless you are
familiar with its safe operation. If you are not
familiar with the operation of a Drill Press seek
advice from your supervisor, instructor or other
qualified individual.
3. If you are using a bench top Drill Press, it must
be securely fastened to a stand or bench.
4. If you are operating a floor Drill Press it must
be securely fastened to the floor.
5. Always clear the table and work area before
turning on the Drill Press.
6. Always use drill bits, cutting tools and
accessories with a 1/2” shank or less.
7. Never place hands near the drill bit, cutting tool
or accessory.
8. Never wear loose clothing, gloves or ties while
operating the Drill Press.
9. Always have a firm footing while operating the
Drill Press.
10.Always keep work surface and work areas clear
of debris.
11. Never attempt to do set-up work, assembly or
layout work on the Drill Press while it is in
operation.
12.Never start the Drill Press with the drill bit,
cutting tool or accessory in contact with the
work-piece.
13.Always lock all table, column and head locks
before turning on the Drill Press.
14.Never operate the Drill Press with a damaged
drill bit, cutting tool or accessory.
15.Always check the drill bit, cutting tool or
accessory in tight in the chuck.
16.Never operate the Drill Press with the chuck
key in the chuck.
17.Always adjust the depth stop to avoid drilling
into the table surface.
18.Never drill material unless it is properly
supported. Non flat work-pieces require
additional support.
19.Always clamp the work piece to the table.
20.Always support large work-pieces at the same
height as the table.
21.Never remove the work-piece or clear the
table until the Drill Press comes to a complete
stop.
22.Always wear a face shield and safety glasses
while operating the Drill Press.
23.Never operate the Drill Press with missing,
damaged, worn, loose or defective parts.
24.Never adjust, change speeds or perform
maintenance on the Drill Press while it is
operating.
25. Always clean the work surface and work area
when finished operating the Drill Press.
26. Always disconnect the power when adjusting
or performing maintenance on the Drill Press.
27.Always disconnect the power when finished
using the Drill Press to prevent accidental
operation.