RIKON Power Tools 10-308 User Manual

Page 10

Fence Assembly

There are 2 fences to support the meat and adjust for slice
thickness.
 Gather up the following parts and components

a. Rod Holders (2)

b. Lock Knobs (2)

c. Long Rod (1)

d. Short Rod (1)

e. Short Fence (1)

Long Fence (1)

g. Hex Head Bolts (4)

h. Set Screws (2)

 Mount the 2 rail holders to the front and left side of the

sliding table using the hex bolts provided.

 Insert the longer rod into the longer fence and attach

with the set screw.

 Insert the shorter rod into the shorter fence and attach

with set screw

 Slide the longer fence into the rod holder on the left

side of the sliding table and tighten with the locking
knob provided.

 Slide the shorter fence into the rod holder on the front

of the sliding table and tighten using the locking knob
provided.

 You can use the locking knobs to adjust the location of

the fences.

 You can also swap the rods and fences around for bet-

ter sizing.

Meat Grinder Assembl

The internal parts of the meat/sausage grinder are shown
at left. CAUTION! Make sure you do not attach the grinder
to the saw unless you are ready to grind meat. Meat acts
as a lubricant so operating the grinder dry will damage it.

** Attach the grinder's Bracket (part #66) to the rear panel of
the saw with the 2 Hex Bolts and Flange Nuts (#78). The
motor's Drive Shaft (#73) will go through the bracket.

 Gather up the following components and parts.

a. Meat Grinder

b. Hex Bolt

(1)

c. Hex Nut (1)

 At the bottom of saw base is where the flat drive for the

grinder comes out. The grinder end has a mating slot
for connecting the grinder to the saw, which in turn
drives the worm drive.

 Looking at the end of the grinder there is a correspond-

ing slot that needs to be lined up with the flat point in-
side the grinder holder. Rotate to line up if necessary.

 Slide the female end of the grinder over the male end

grinder holder making sure the slot is lined up and se-
cure using the hex bolt and nut provided.

 Make sure the grinder will turn and run smoothly.
 Remember do not operate the grinder dry.

Assembly