RIKON Power Tools 10-315 - Manual (Page 9)

Mounting Top to Stand
Feed the long mounting bolts up through the stand
and secure the four corners using the washers and
bolts provided (A-Fig.1) . Lift the bandsaw over the
stand and place the long mounting bolts through the
four location holes in the bandsaw base .
Assemble Working Table
Installing 90°stop: Thread screw (M8x25) and nut
(M8) to the bottom of the table. (A-Fig.2) With
the help of another person, lift the working table
onto the trunnion. Mount the working table to the
trunnion using the supplied (4) hex bolts, (4) lock
washers and (4) washers (B-Fig.2). Install the two
bolts to the right of the blade hand tight, then tip the
table to 45 degrees and install the two bolts to the
left of the blade. Adjust table parallel to blade and
tighten bolts.
Table Leveling Bar: The table leveling bar is
preinstalled from the factory and must be removed
before installing the table. The table leveling bar
keeps the two sides of the blade slot level.
(C-Fig. 2)
Fence Support Bolt: Install the fence support bolt in
the left rear corner of the table. (D-Fig. 2)
Figure 1
Figure 4
9
A
B
Figure 2
Figure 3
Assembly
Rip Fence Assembly
Mount the fence bar onto the table with the two
fence bar nuts.(A-Fig 3) Do not fully tighten yet as
they may need to be adjusted later. The bar should
be installed so that the longest amount of bar is on
the left hand side allowing the fence to be attached.
Place the brass lock shoe into the fence seat.(A-
Fig 4) Position the fence assembly onto the fence
bar(B-Fig 4). Lay the fence on to the table and lock
by tightening the fence lock knob. (B-Fig 5)
A
B
B
Figure 5
C
A
Underside of Table
D
A