Rhino Shelter HOUSE-12W X 20L X 8H - Manual (Page 2)

Assembly Instructions House Style 12 x 20 x 8
6 TC-2000 Top Crest Tube
8 CSU-2001 Center Straight Uprights
2 CW-2005 Corner Wind Brace
20 SCR-2004 Swedged Cross Rails
5 ECR-2003 End Cross Rails – Plain End
8 TB-3004 Turnbuckles
30 CBN-3005-3 Carriage Bolts – 3 1/4”
2 CBN-3005-2 Carriage Bolts – 2 ¼”
Note: All Side and Base Ridge Poles MUST be on
Inside of Arch Frame Members. Top Ridge Poles
MUST be on Outside of Arch Frame members,
except at Ends. See Frame Assembly Step 5.
P
u
a
V2.2
Do NOT Return Assembly To Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
2
32 CBN-3005-N 9/16” Nuts
32 CBN-3005-W Washers – 9/16” Cupped
2 R-3003 3/16” Rope
4 BC-36 Bungee Cord Hold Ups
6 DBA-3000 Earth Cable Anchors
6 UB-3002 U Bolts with Nuts
1 DR-3001 36” Drive Rod
4 EP-1000 1-5/8” Plastic End Plugs
10 EP-1001 1” Plastic End Plugs
Wind Brace
Bottom Cross
Rail
Top Ridge Cross Rail
End Arch with Foot
Side Cross
Rail
Interior Arch
Take notice of drainage around your intended location.
Water draining from the surrounding terrain should be
planned so that it does not run into the unit. As well, rain
or melting snow that comes off the unit should be
drained away rather than accumulate and pool around
the unit. SITE PREPARATION
Select a level or as close to level as practical location for
your Rhino Shelter unit. The unit should be placed on a
base of materials suitable for the storage load to be
protected. The unit should not be located under trees,
which will shed hard fruit such as apples, walnuts, or
heavy pine cones. The cover of your unit will protect
against normally leaves and light debris, however large
branches or other falling items may cause puncture or
tears in the cover material.
Check to be certain that adequate clearance is allowed
for entry and exit from ends of unit. As unit has doors on
both ends, ideally vehicle or contents can be inserted or
removed from either end.