Lincoln Electric IM759 WELD-PAK 3200HD - Manual (Page 9)

A-2 INSTALLATION
WELD-PAK 3200HD
A-2
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the WELD-
PAK 3200HD from its carton and remove all packing
material around the WELD-PAK 3200HD. Remove the
following loose items from the carton (see Figure A.1):
1. WELD-PAK 3200HD
2. Gun and cable assembly (1)
3. Literature and miscellaneous including:
a) This operating manual
b) 3 extra .023"-.025” (0.6 mm) contact tips
c) 3 extra .035” (.09mm)contact tips
d) Hex key wrench for removal of drive roll.
4. 10 ft (3.0 m) work cable.
5. Work clamp.
6. Sample spool of .025” (0.6 mm) L-56 MIG wire.
7. Sample spool of.035” (.09mm) NR-211 MP
Innershield Flux Cored Wire
8. Handshield with filter plate and lens.
9. Adjustable mixed-Gas Regulator & Hose.
10. Mig Nozzle Assembly
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the WELD-PAK 3200 HD Operating
Manual should install and operate this
equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The WELD-PAK 3200 HD power switch is
to be in the OFF (“O”) position when
installing work cable and gun and when
connecting power cord to input power.
WARNING
FIGURE A.1
1
2
3
4
7
8
9
6
5
11. Undercarriage:
a) Base
b) Gas bottle support base
c) (2) Gas bottle support brackets
For available options and accessories refer to the
Accessories Section of this manual.
1) As shipped from the factory, the WELD-PAK
3200HD gun liner is ready to feed .023
” (0.6 mm) -
.035 (0.9 mm) wire. The contact tip is sized for .023 ” -
.025 ” (0.6 mm) wire feeding.