Lincoln Electric IM744 VANTAGE 575 - Manual (Page 23)

21. CIRCUIT BREAKERS
These circuit breakers provide separate overload current
protection for each 220V receptacle, the 42VAC AND 115VAC in
the 14-Pin connector and battery circuit overload protection.
22. 220VAC RECEPTACLES
These three 220VAC receptacles provide up to 15 amp rating
each. Refer to the AUXILIARY POWER RECEPTACLES section
in the installation chapter for further information about these
receptacles. Also refer to the AUXILIARY POWER OPERATION
section later in this chapter.
23. EARTH STUD
Provides a connection point for connecting the machine case to
earth. Refer to “MACHINE EARTHING” in the Installation chapter
for proper machine earthing information.
24. RCD
Residual Current Device provides protection from Active to Earth
contact.
It will not protect against electric shock resulting from contact with
Active and Neutral Wires.
25. 3 phase Circuit Breaker
Provides over current protection for the Auxiliary Outputs.
ENGINE OPERATION
STARTING THE ENGINE
1. Open the engine compartment door and check that the fuel
shutoff valve located to the left of the fuel filter housing is in the
open position (lever to be in line with the hose).
2. Check for proper oil level and coolant level. Close engine
compartment door.
3. Remove all plugs connected to the AC power receptacles.
4. Set IDLER switch to “AUTO”.
5. Set the RUN/STOP switch to “RUN”. Observe that the engine
protection and battery charging lights are on. After 10 seconds,
the engine protection light will turn off.
6. Within 30 seconds, press and hold the engine START button
until the engine starts.
7. Release the engine START button when the engine starts.
8. Check that the engine protection and battery charging lights
are off. The engine protection light is on after starting, the
engine will shutdown in a few seconds. Investigate any
indicated problem.
9. Allow the engine to warm up at low idle speed for several
minutes before applying a load and/or switching to high idle.
Allow a longer warm up time in cold weather.
COLD WEATHER STARTING
With a fully charged battery and the proper weight oil, the engine
should start satisfactorily even down to about -10°C. If the engine
must be frequently started below -40°C, it may be desirable to
install the optional ether starter kit (K887-1). Installation and
operating instructions are included in the kit.
STOPPING THE ENGINE
1. Switch the RUN/STOP switch to “STOP”. This turns off the
voltage supplied to the shutdown solenoid. A backup shutdown
can be accomplished by shutting off the fuel valve located on
the fuel line.
B-5 OPERATION B-5
Vantage 575