Lincoln Electric IM993 VANTAGE 300 - Manual (Page 28)

D-1 MAINTENANCE D-1
VANTAGE ® 300
SAFETY PRECAUTIONS
• Have qualified personnel do all maintenance
and troubleshooting work.
• Turn the engine off before working inside the
machine or servicing the engine.
• Remove guards only when necessary to
perform maintenance and replace them when
the maintenance requiring their removal is
complete. If guards are missing from the
machine, obtain replacements from a Lincoln
Distributor. (See Operating Manual Parts List.)
Read the Safety Precautions in the front of this
manual and in the Engine Ownerʼs Manual before
working on this machine.
Keep all equipment safety guards, covers, and
devices in position and in good repair. Keep
hands, hair, clothing, and tools away from the
gears, fans, and all other moving parts when
starting, operating, or repairing the equipment.
WARNING
Routine Maintenance
At the end of each dayʼs use, refill the fuel tank to
minimize moisture condensation in the tank. Running
out of fuel tends to draw dirt into the fuel system.
Also, check the crankcase oil level and add oil if
indicated.
Engine Oil Change
Drain the engine oil while the engine is warm to
assure rapid and complete draining. It is recommend-
ed that each time the oil is changed the oil filter be
changed as well.
• Be sure the unit is off. Disconnect the negative bat-
tery cable to ensure safety.
• Locate oil drain hose and valve in bottom of base
and pull through the hole in the battery access panel
on the welder.
• Remove the cap from the drain valve. Push valve in
and twist counterclockwise. Pull to open and drain
the oil into a suitable container for disposal.
See engine manual for complete engine care.
FIGURE D.1