Lincoln Electric IM794 SP-170T - Manual (Page 21)

C-1
C-1 ACCESSORIES
OPTIONAL ACCESSORIES
1. K549-1 .035" (0.9 mm) Innershield® Welding Kit
—
Includes a contact tip, a gasless nozzle and a
.030/.035" (.8/.9 mm) cable liner to permit the
Magnum
™ 100L gun and cable to use .035" (0.9
mm) diameter flux-cored electrode. The fitting on
the end of the liner is stenciled with the maximum
rated wire size (.045"/1.2 mm). Also included is a
10 lb.(4.5 kg.) spool of .035" (0.9 mm) Innershield
®
NR-211-MP.
See “ Innershield (FCAW) Conversion ” in this sec-
tion for installation instructions and MAINTE-
NANCE section for proper feeding component con-
figuration and installation.
2. K549-2 .045" (1.2 mm) Innershield® Welding Kit
—
Includes a contact tip, a gasless nozzle and a
.035/.045" (0.9/1.2 mm) cable liner to permit the
Magnum
™ 100L gun and cable to use .045" (1.2
mm) diameter flux-cored electrode. The fitting on
the end of the liner is stenciled with the maximum
rated wire size (.045"/1.2 mm). Also included is a
10 lb.(4.5 kg.) spool of .045" (1.2 mm) Innershield
®
NR-211-MP and a knurled drive roll.
See “ Innershield (FCAW) Conversion ” in this sec-
tion for installation instructions and MAINTE-
NANCE section for proper feeding component con-
figuration and installation.
3. K664-2 Aluminum Feeding Kit — This kit is rec-
ommended for welding with .035 Aluminum wire.
Included with this kit are a drive roll, cable liner and
.035 contact tip.
It is important when changing
between welding with steel wire and aluminum
to exchange feeding components due to the
lubricant applied to steel wire. Failure to do so
may result in contaminated welds when welding
aluminum.
See Maintenance section for instructions on
installing drive roll, cable liner, contact tip and their
proper configuration.
4. KP665-045C Drive Roll – Optional — Knurled
drive roll for feeding .035 - .045 ” (0.9 - 1.2 mm)
diameter flux-cored electrode.
5. K520 Utility Cart — Designed to transport the
Lincoln family of small welders. Has provisions for
mounting a single gas cylinder. Has front casters
and large rear wheels. Handle height is easily
adjustable. Bottom tray provided for tools and
accessories. Easy assembly required; takes less
than 15 minutes.
6. K586-1 Deluxe Adjustable Gas Regulator &
Hose Kit
Accommodates CO
2
, Argon or Argon-blend gas
cylinders. Includes a cylinder pressure gauge and
4.3 ft. (1.3m) gas hose.
7. K697-2 Power Cord Extension — Extension 230V
power cord (20 ’ /6.1m) allows extra convenience
when work is located some distance away from
power receptacle.
8. K667-1 230 Volt 50 Amp Receptacle — For pro-
viding power for your SP-170T at your welding loca-
tion. NEMA standard 6-50 R receptacle. See
“ Line
Cord Connection ” in INSTALLATION section for
recommended wire size.
(1) This regulator comes standard with a 4.5 foot hose
with the SP-170T.
SP-170T