Lincoln Electric IM581 SAE400 - Manual (Page 20)

C-1 ACCESSORIES C-1
K799 Hi-Freq™ - Provides high frequency plus a gas
valve for TIG welding. A water valve is available as an
option. Requires 115 volt AC input. (Limited to 250A -
60% Duty Cycle).
K802-C Power Plug Kit - Kit includes male plugs for
each auxiliary receptacle.
K805-1 Ether Start Kit - Injects ether for starting aid.
Recommended only when engines are frequently
started at temperatures under 10°F (-12°C). Ether
cylinder is not included.
K767-1 Trailer - A 4-wheel steerable trailer for in-plant
and yard towing
(1) with E78-14 load range (B) tubeless
tires. Mounts directly to welder base.
K956-1 and -2 Trailer - A 2-wheel trailer designed for
road
(1) , off road, in-plant and yard towing. The K956-2
trailer is equipped with electric brakes. Trailer mounts
directly to welder base.
1 For highway use, consult applicable federal, state and local laws regarding
possible requirements for brakes, lights, fenders, etc.
Linc-Thaw™ (L2964-3) - Includes meter and fuse to
protect the welder when thawing frozen water pipes.
Pipe Thawing IS NOT a CSA approved procedure. If
not done properly, it can result in fire, explosion,
damage to wiring which may make it unsafe, dam-
age to pipes, burning up the welder or other haz-
ards.
IMPORTANT: DO NOT USE A WELDER TO THAW
A PIPE BEFORE REVIEWING LINCOLN BULLETIN
E695.1 (dated October 1987 or later). This bulletin
may be obtained from your local Lincoln distributor or
by writing directly to Lincoln Electric at the address on
the back of this manual.
K704 Standard Accessory Kit - Includes electrode
and work cables, headshield, work clamp and elec-
trode holder.
K385-1 CV Adapter - Provides constant voltage output
for semiautomatic welding. (Field installation only).
SAE400 WELD’N AIR
WARNING