Lincoln Electric IM740 PRO-MIG 135 - Manual (Page 9)

A-2 INSTALLATION
Pro-MIG 135
A-2
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the Pro-MIG
135 from its carton and remove all packing material
around the Pro-MIG 135. Remove the following loose
items from the carton (see Figure A.1):
1. Pro-MIG 135
2. Gun and cable assembly (1)
3. Literature and miscellaneous including:
a) This operating manual
b) 2 extra .023"-.025” (0.6 mm) contact tips
c) 3 extra .035” (0.9 mm) contact tips
d) Hex key wrench for removal of drive roll.
4. 10 ft (3.0 m) work cable.
5. Work clamp.
6. a) Sample spool of .025” (0.6 mm) L-56 MIG wire.
b) Sample spool of Innershield .035” (0.9 mm)
NR-211-MP.
7. Hand shield with filter plate and lens.
8. Adjustable mixed-Gas Regulator & Hose.
9. Instructional video.
10. Gasless Nozzle.
For available options and accessories refer to the
Accessories Section of this manual.
1) As shipped from the factory, the Pro-MIG 135 gun
liner is ready to feed .023” (0.6 mm) -.035 (0.9 mm)
wire. The contact tip is sized for .023”-.025” (0.6
mm) wire feeding.
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the Pro-MIG 135 Operating Manual
should install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The Pro-MIG 135 power switch is to be in
the OFF (“O”) position when installing
work cable and gun and when connecting
power cord to input power.
WARNING
FIGURE A.1
1
2
3
4
6
7
8
5
Pro-MIG
™ 135
9
10