Lincoln Electric IM917 POWER WAVE 405M - Manual (Page 11)

A-2 INSTALLATION
POWER WAVE® 405M
A-2
SELECT SUITABLE LOCATION
The Invertec POWER WAVE® 405M will operate in
harsh environments. Even so, it is important that sim-
ple preventative measures are followed in order to
assure long life and reliable operation.
• The machine must be located where there is free cir-
culation of clean air such that air movement in the
back, out the sides and bottom will not be restricted.
• Dirt and dust that can be drawn into the machine
should be kept to a minimum. Failure to observe
these precautions can result in excessive operating
temperatures and nuisance shutdown.
• Keep machine dry. Shelter from rain and snow. Do
not place on wet ground or in puddles.
• DO NOT MOUNT OVER COMBUSTIBLE SURFACES.
Where there is a combustible surface directly
under stationary or fixed electrical equipment,
that surface shall be covered with a steel plate at
least .06”(1.6mm) thick, which shall extend not
less than 5.90”(150mm) beyond the equipment on
all sides.
----------------------------------------------------------------------
STACKING
POWER WAVE® 405M cannot be stacked.
TILTING
Place the machine directly on a secure, level surface
or on a recommended undercarriage. The machine
may topple over if this procedure is not followed.
INPUT AND GROUNDING CONNECTIONS
• Only a qualified electrician should connect the
Invertec POWER WAVE® 405M. Installation should
be made in accordance with the appropriate
National Electrical Code, all local codes and the
information detailed below.
• When received directly from the factory, multiple
voltage machines are internally connected for
400VAC. If 400VAC is the desired input, then the
machine may be connected to the power system
without any setup required inside the machine.
SAFETY PRECAUTIONS
ELECTRIC SHOCK can kill.
• Turn the input power off at the dis-
connect switch before attempting to
connect or disconnect input power
lines, output cables or control
cables.
• Only qualified personnel should perform this
installation.
• Connect the green or green/yellow lead of the
power cord to ground per U.S.National
Electrical Code.
----------------------------------------------------------------------
WARNING
• Initial 200VAC - 230VAC operation will require an
Input voltage panel setup.
• Open the access panel on the rear of the machine.
• For 200 or 230: Position the large switch to 200-
230.
• For higher voltages: Position the large switch to
greater than 380.
• Move the "A" lead to the appropriate terminal.
POWER CORD CONNECTION
A 10ft.(3.5m) power cord is provided and wired into
the machine. Follow the power cord connection
instructions.
• Incorrect connection may result in equipment
damage.
----------------------------------------------------------------------
Single Phase Input
Connect green/yellow lead to ground per National
Electrical Code.
Connect blue and brown leads to power.
Wrap blue lead with tape to provide 600V insulation.
Three Phase Input
Connect green/yellow lead to ground per National
Electric Code.
Connect black, blue and brown leads to power.
UNDERCARRIAGE MOUNTINGS
W AR NIN G W AR NIN G AV IS O DE PR EC AU CIO N
AT TE NTI ON
!
!
!
!
Lore m ip sum do lor sit am et c ons ecte tue r ad ipis cing Lore m ips um dol or sit a me t con sec tetue r ad ipis cing elit, ed dia m n on elit, ed dia m non um m um my nib h e uism od t incid unt ut y n ibh eui sm od tinc idun t ut laor eet do lor e m agna aliq uam er laor eet dol ore ma gna aliq uam era t at Lor em ips um dol or s it a me t con sec tet uer adi pisc ing Lor em ipsum dol or s it am et c ons ecte tue r ad ipis cin g elit, ed dia m n on elit, ed dia m non um m um my nib h e uism od t incid unt ut y ni bh euis mod tinc idun t ut laor eet do lore m agn a a liqu am er laor eet do lore ma gna aliq uam era t at Lor em ips um do lor s it a me t co nse ctet uer adi pis cing Lor em ipsu m do lor sit a me t co nse cte tue r ad ipis cin g elit, ed diam no n elit, ed dia m no num m um my nib h e uism od t incidun t ut y n ibh euis mo d tin cidu nt u t lao ree t do lore m agn a a liqu am er lao ree t do lor e m ag na aliq uam erat at Lore m ip sum do lor sit am et c ons ecte tue r ad ipis cing Lore m ipsu m dolor sit am et c on sec tet uer adi pisc ing elit, ed dia m no n elit, ed diam non um m um my nib h e uism od t incidu nt u t y n ibh euis mod tinc idu nt u t lao ree t do lore m ag na aliqu am er lao ree t dol ore ma gn a a liqu am era t at Lo rem ips um dol or s it am et c on sec tet ue r ad ipis cin g Lo rem ipsum dolo r sit am et con sec tet ue r ad ipis cing elit, ed dia m n on elit, ed dia m non um m um my nibh euis mo d tin cidu nt u t y n ibh euis mo d tinc idun t ut laor eet dol ore m agna aliqu am er laor eet dolor e m agna aliq uam erat at Lor em ips um do lor sit a met con sec tetu er a dipi scing Lore m ipsum dolo r sit am et c ons ecte tue r ad ipis cing elit , ed dia m n on elit, ed dia m non um m um my nib h e uism od tinc idun t ut y n ibh euis mod tinc idun t ut lao ree t do lor e m agna aliq uam er lao ree t do lore ma gna aliqua m era t at Lor em ips um do lor s it a me t co ns ec tet uer adi pisc ing
Lor em ipsu m dolo r sit am et c ons ecte tue r ad ipis cing elit, ed diam no n elit, ed dia m non um m um my nib h e uism od t inc idu nt ut y n ibh eui sm od tinc idu nt ut lao reet do lore m agn a a liqu am er lao ree t do lore ma gna aliq uam era t at Lore m ip sum do lor s it a me t co nse cte tuer adi pisc ing Lor em ipsu m dolo r sit am et con sec tetu er adipi scin g elit , ed dia m n on elit, ed dia m non um m um my nib h e uism od t incid unt ut y n ibh eui sm od tinc idu nt ut lao ree t do lore m agn a a liqu am er lao ree t do lore ma gna aliq ua m erat at Lor em ips um do lor s it a met co nse cte tuer adi pisc ing Lor em ipsu m dolo r sit am et c ons ecte tuer ad ipis cing elit, ed diam no n elit, ed diam non um m um my nib h e uism od t inc idu nt ut y n ibh euis mo d tin cidun t ut laor eet do lor e m agna aliq uam er laor eet do lore magn a a liqua m era t at
Lore m ip sum do lor s it am et c on sec tet uer adi pisc ing Lore m ipsum dol or s it a me t co ns ecte tuer ad ipis cing elit, ed diam no n elit, ed diam no num m um my nibh eu ism od tinc idunt ut y n ibh eu ism od tinc idun t ut lao ree t do lor e m agn a a liqu am er lao ree t dol ore magn a al iqu am era t at Lor em ips um do lor s it a me t co nsec tetu er ad ipis cing
Lor em ipsu m do lor sit a met con sec tet ue r ad ipis cin g elit, ed dia m n on elit, ed dia m non um m um my nib h e uism od tinc idu nt u t y n ibh euis mo d tin cidu nt u t lao ree t do lore mag na aliq uam er lao ree t do lor e m ag na aliq uam erat at Lo rem ips um dol or s it a me t co nsec tet ue r ad ipis cin g
Lo rem ipsum dolo r sit am et cons ectet ue r ad ipis cing elit, ed dia m n on elit, ed dia m non um m um my nibh eu ism od tinc idu nt u t y n ibh eu ism od tinc idun t ut laor eet do lore m agna aliq uam er laor eet dolo re ma gna aliq ua m era t at Lore m ip sum do lor s it a me t con sec tet ue r adi pisc ing
Lore m ipsum dolo r sit am et con sec tet uer adip iscin g elit, ed dia m no n elit, ed dia m non um m um my nib h e uism od t inc idun t ut y n ibh euis mo d tin cidu nt u t lao ree t do lore m agn a a liqua m e r lao ree t do lore ma gna aliqu am erat at Lore m ipsu m d olo r sit am et c ons ect etu er a dipi scin g
Lore m ipsu m dol or s it a me t co nse cte tuer adipi scing
eli t, e d di am no n eli t, e d di am no num m um my nibh eu ism od t incidu nt u t y n ibh euis mod tincidu nt ut
lao ree t do lore ma gn a a liqu am er lao ree t do lore ma gn a a liqu am era t at Lore m ip sum do lor s it a me t co nse cte tue r adi pisc ing
Lore m ipsum dolo r sit am et c ons ecte tue r adi pis cing
elit , ed dia m n on elit , ed dia m non um m umm y n ibh eu ism od t incid un t ut y n ibh euis mo d tin cidun t ut
lao reet do lore ma gna aliq ua m e r lao reet dol ore ma gna aliq uam era t at Lore m ipsu m d olo r sit amet co nse cte tuer ad ipis cing
Lore m ipsum dolo r sit am et c ons ecte tuer adip iscing
elit, ed dia m n on elit, ed dia m non umm umm y ni bh e uis mo d tinc idu nt u t y ni bh euis mo d tin cid unt ut
lao ree t do lore m agn a a liqua m e r lao ree t do lore ma gna aliq ua m era t at Lo rem ipsu m d olo r sit ame t co ns ec tetu er a dip iscin g
Lo rem ipsu m dolor sit a me t co nse cte tue r adip iscin g
elit, ed d iam non elit, ed dia m non um m um my nib h e uism od t incid unt ut y n ibh euism od tinc idu nt ut
laor eet dolo re ma gna aliq uam er laor eet dolo re ma gna aliqu am era t at
Lor em ips um do lor s it a met con sec tetu er ad ipis cing
Lor em ipsu m dolor sit a met con sec tetu er a dip iscing elit, ed dia m n on elit, ed dia m non um m um my nib h eu ism od t incid unt ut y ni bh eu ism od tinc idu nt u t lao ree t do lore m ag na aliqu am er lao ree t do lor e m ag na aliq uam era t at Lo rem ips um do lor sit a me t co nse cte tuer ad ipis cin g
Lo rem ipsu m dolor sit a met con sec tetuer adip iscin g
elit, ed dia m no n elit, ed diam non um m um my nib h eui sm od tinc idu nt u t y n ibh eui sm od tinc idun t ut laor ee t do lore m agna aliqu am er laor ee t do lore ma gna aliq uam era t at
W AR NIN G RE M OT E
PO W ER
OF F
ON
P O W E R W A V E 3 5 5
GREEN / YELLOW
BLUE
BLACK
BROWN
5.50
10.00
MOUNTING HOLE LOCATIONS
M19527
1/4-20 NUT (4 PLACES)
NOTE: MOUNTING SCREWS CA
10/01
N NOT PROTRUDE MORE THAN
0.5 INCHES INSIDE THE MACHINE.
11.84
3.50
CAUTION
CAUTION