Lincoln Electric IM850 POWER FEED 10S - Manual (Page 17)

C-1 ACCESSORIES C-1
K2311-1 MOTOR CONVERSION KIT (FOR
142:1 NA STYLE WIRE DRIVES)--
This conver-
tion kit converts old NA style wire drives.
1. Remove the 2 hex head screws and the 2 slot head
screws holding the Motor to the Wire Drive Gearbox
assembly.
2. Remove existing Adapter Plate and Motor Assembly.
3. The Conversion Kit Motor is shipped configured for a
142:1 gear ratio. The existing gearbox must be con-
figured for a 142:1 gear ratio for the Conversion Kit to
assemble correctly. If both assemblies are not con-
figured for the same gear ratio, this must be done
before continuing. (See Gear Ratio Conversion Kit
instructions.)
4. Cover the teeth of the new Motor pinion gear with a
non-fluid molydisulfide type grease such as Non-Fluid
Oil Corporation’s A-29 Special/MS Lubricant. This
grease can be scooped from the cavity of the gear
case First Chamber.
5. Reassemble the new Adapter Plate and Motor
Assembly on the Wire Drive Gearbox; making sure
the gears mesh properly and the Adapter Plate locat-
ing bead is in its cavity. Replace and tighten the 4
screws removed in step 1.
POWER FEED 10S