Lincoln Electric IM526 INVERTEC V300-Pro - Manual (Page 30)

– 30 –
Only qualified persons should install, use or service this machine.
using the disconnect switch at the fuse box
WARNING
Turn off input power to the Welding Power Source
Before connecting the wire feeder.
ELECTRIC
SHOCK
CAN KILL
N.A. WELDING CABLE MUST BE SIZED FOR CURRENT AND DUTY CYCLE OF APPLICATION.
TO WORK
- +
14 PIN AMPHENOL
ELECTRODE CABLE TO LN-9 GMA
K596 REMOTE CONTROL CABLE ASSEMBLY
INVERTEC POWER SOURCE WITH 110/115V AUX.
N.B. DIAGRAM SHOWS ELECTRODE POSITIVE. TO CHANGE POLARITY, TURN POWER "OFF", REVERSE ELECTRODE AND WORK CABLE AT POWER SOURCE. SET METER POLARITY SWITCH ON REAR OF INVERTEC TO COINCIDE WITH POLARITY USED. SET LN-9 GMA POLARITY SWITCH ALSO. N.D. FOR GMAW WELDING, INSTALL PULSE POWER FILTER KIT K442-1 IN LN-9 GMA. N.C. INSTALL K608-1 ADAPTER IN LINE WITH P10 TO LN-9 GMA VOLTAGE BOARD PER INSTRUCTIONS IN V300 MANUAL.
LN-9 GMA WITH K608-1 AND K442-1 KITS.
S20607
P10’,J10
2 3 4 5 6 7 10 11 12
P10,J10’
2 3 4 5 6 11 12 7
3.9K
K608-1 CONNECTION DETAIL
530A 521 500 500 524
C B
533
9-29-95C
LN-9 GMA WITH K596 CABLE TO INVERTEC - CONNECTION DIAGRAM