Lincoln Electric IM544 Commander 400 - Manual (Page 39)

F-7 DIAGRAMS F-7
COMMANDER 400
CONNECTION DIAGRAM:
ELECTRODE
TO WORK
S22914 12-13-96
CAUTION : AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN THE ENGINE WELDER OPERATING MANUAL.
N.A. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE RANGE SWITCH TO "WIRE WELDING CV".
APPLICATIONS. SEE OPERATING MANUAL.
N.B. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED, PLACE LOCAL REMOTE SWITCH IN "REMOTE" POSITION.
COMMANDER 400 STICK & WIRE / LN-7 CONNECTION DIAGRAM
TO LN-7 INPUT CABLE PLUG
14 PIN
K584 OR K594CONTROL CABLE
AMPHENOL
OPTIONAL K857 REMOTE CONTROL
6 PIN AMPHENOL
ELECTRODE CABLE
TO WORK
TO WIRE FEED UNIT
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
Keep guards in place. or service this equipment. Keep away from moving parts. Only qualified personnel should install,use
Do not touch electrically live parts. before servicing. Disconnect NEGATIVE (-) BATTERY LEAD Do not operate with panels open.
WARNING