Lincoln Electric IM732 INVERTEC V350-PRO (CE) - Manual (Page 18)

C-1 ACCESSORIES C-1
OPTIONS / ACCESSORIES
• The V350-PRO (CE) provides the hardware to power
and connect to 24 or 42 wire feeders.
K857 Remote Output Control
K814 Arc Start Switch
K812 Hand Operated Amptrol
K870 Foot Operated Amptrol
K428, K446, K449 LN-25
K617 (-1 or -2) K618 (-1 or -2) LN-742
K1559-1, K1564-1
LN-10
K1499-1, K1521-1 DH-10
K1587-1 Cobramatic
Welding Cable Connectors:
• K852-70 1/0-2/0 cable
• K852-95 2/0-3/0 cable
FIELD INSTALLED OPTIONS
• K1762-2 TIG Gas Control Kit
• K1764-1 Undercarriage
• K1838-1 Valet Style Undercarriage
INVERTEC® V350-PRO (CE)
QUICK DISCONNECT PLUGS
A quick disconnect system is used for the welding
cable connections. The The K852-70 is designed to
accept a welding cable size of 1/0 to 2/0.
1. Remove 25mm (1 in.) of welding cable insulation.
2. Slide rubber boot onto cable end. The boot end
may be trimmed to match the cable diameter.
Soap or other lubricant will help to slide the boot
over the cable.
3. Slide the copper tube into the brass plug.
4. Insert cable into copper tube.
5. Tighten set screw to collapse copper tube. Screw
must apply pressure against welding cable. The
top of the set screw will be well below the surface
of the brass plug after tightening.
6. Slide rubber boot over brass plug. The rubber
boot must be positioned to completely cover all
electrical surfaces after the plug is locked into the
receptacle.
25 mm
1 in.
WELDING CABLE
BOOT
TRIM
SET SCREW
BRASS PLUG
COPPER TUBE