Johnson Level & Tool Mfg. 40-6006 - Manual (Page 9)

Single Distance Measuring
1. Press the measure button to turn on the unit.
2. Point the laser beam to the target.
3. While holding the unit steady, press the measure button again
to make the measurement.
4. Unit will beep once, measurement will be displayed on the main
screen and the laser beam will turn off.
5. Press the button again, the laser beam will turn on and the first
measurement will go to the sub-screen.
6. Point the laser beam to the next target and press the button
again. The new measurement will be displayed on the main screen
and the prior measurement on the sub-screen.
7. This can be repeated over and over again.
8. To clear, push the button once and the unit will beep once.
9. To power off, press the button for 3 seconds. The unit will give
a long beep.
©2013 Johnson Level & Tool - Rev. 1 9
3. Press the button to switch from the front of the unit to the
rear of the unit.
4. To exit, press the button to begin operations
7349H-English_Manuals 9/6/13 1:55 PM Page 9