Johnson Level & Tool Mfg. 40-6006 - Manual (Page 10)

10 ©2013 Johnson Level & Tool - Rev. 1
Continuous Measuring
1. After the unit is powered on, hold the button in for 2 seconds,
the LCD display will change from single ( ) to continuous
( ) display.
2. This mode will take continuous measurements as you move closer
or farther away from the target.
3. Minimum working range is 2", maximum working range is 100’.
4. Press the button once to hold the continuous measuring mode.
Press to resume continuous measuring mode.
5. Press the button to clear this mode.
Adding Measurements
1. To add additional measurements after taking the first measurement,
press the function button once.
2. The first measurement will move to the sub-screen and the laser
beam will be on. The add sign (+) by the main screen will be flashing.
3. Point the laser beam to the next target and press the button.
4. The first measurement will be displayed on the sub-screen and the
combined measurements will be displayed on the main screen.
5. To add additional measurements, press the button again.
The (+) sign will be on and the combined measurements will move
to the sub-screen.
6. Press the button and the new measurement will be displayed
on the sub-screen and total measurement on the main screen.
7. Repeat as often as desired.
7349H-English_Manuals 9/6/13 1:55 PM Page 10