FallTech Beam Anchors - Manual (Page 20)

39
It is the responsibility of the employer/issuer of this equipment to
ensure that it is used in a manner consistent with these instructions.
Failure to do so could result in series injury or death.
For further reading and additional information, see Section 10.4 for a
listing of relevant standards with which you should be familiar.
10.2: Performance Specifications
Ratcheting/Sliding Beam Anchors
7411 7490 7530 7531
Material of
Construction:
Jaws
Stainless
Steel
Stainless
Steel
Alloy Steel Alloy Steel
Material of
Construction: Bar
Stainless
Steel
Alloy Steel Aluminum
Alloy
Aluminum
Alloy
Maximum
Capacity:
425 lbs. 425 lbs. 425 lbs. 425 lbs.
Ultimate Strength: 5,000 lbs. 5,000 lbs. 5,000 lbs. 5,000 lbs.
Detent-Pin Beam Anchors
7485 7486
Material of Construction: Jaws Stainless Steel Stainless Steel
Material of Construction: Bar Stainless Steel Stainless Steel
Maximum Capacity: 425 lbs. 425 lbs.
Ultimate Strength: 5,000 lbs. 5,000 lbs.
Fixed-Position Beam Anchors
7487 7488 7533 7534
Material of
Construction:
Jaws
Stainless
Steel
Stainless
Steel
Aluminum
Alloy
Aluminum
Alloy
Material of
Construction: Bar
Stainless
Steel
Stainless
Steel
Aluminum
Alloy
Aluminum
Alloy
Maximum
Capacity:
425 lbs. 425 lbs. 425 lbs. 425 lbs.
Ultimate Strength: 5,000 lbs. 5,000 lbs. 8,000 lbs. 8,000 lbs.
Beam TrolleyAnchors
7710
Material of Construction: Jaws Aluminum Alloy
Material of Construction: Bar Stainless Steel
Maximum Capacity: 425 lbs.
Ultimate Strength: 5,000 lbs.
40
Vertical Beam Anchors
7489 7535 7536
Material of Construction:
Jaws
Aluminum
Alloy
Aluminum
Alloy
Aluminum
Alloy
Material of Construction:
Bar
Stainless
Steel
Aluminum
Alloy
Aluminum
Alloy
Maximum Capacity: 425 lbs. 425 lbs. 425 lbs.
Ultimate Strength: 10,000 lbs. 8,000 lbs. 8,000 lbs.
10.3: Labels and Markings
The label shown below must be present on the product and must be
legible. If it is not, remove the product from service.
Located on end of Beam Anchor Bar
Front side
Back side