Elitegroup PMI8M (V2.0) - Manual (Page 45)

39
Using BIOS
• IRQ Resources: In the IRQ Resources submenu, if you assign an IRQ
to Legacy ISA, then that Interrupt Request Line is reserved for a legacy
ISA expansion card. Press to close the IRQ Resources submenu.
In the Memory Resources submenu, use the first item Reserved Memory
Base to set the start address of the memory you want to reserve for
the ISA expansion card. Use the section item Reserved Memory Length
to set the amount of reserved memory. Press to close the Memory
Resources submenu.
PCI/VGA Palette Snoop (Disabled)
This item is designed to overcome problems that can be caused by some non-standard
VGA cards. This board includes a built-in VGA system that does not require palette
snooping so you must leave this item disabled.
Assign IRQ For USB (Enabled)
“Enable” or “Disable” this item when users are to assign IRQ for the USB interface
onboard.
PC Health Status
On motherboards that support hardware monitoring, this item lets you monitor the
parameters for critical voltages, critical temperatures, and fan speeds.
Shutdown Temperature (Disabled)
Enables you to set the maximum temperature the system can reach before powering
down.
Warning Temperature (Disabled)
Use this item to set the warning temperature level for the processor.
System Component Characteristics
These items allow end users and technicians to monitor data provided by the BIOS on
this motherboard. You cannot make changes to these fields.
• Current CPU Temperature
• CPU Fan Speed
• SYS Fan Speed
• CPU Vcore
• +12V
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
f
Shutdown Temperature [Disabled]
Warning Temperature [Disabled]
Current CPU Temperature
CPU Fan Speed
SYS Fan Speed
CPU Vcore
+12V
+5V
5VSB
VDIMM
NB Vcore
VBAT (V)
Phoenix-AwardBIOS CMOS Setup Utility
PC Health Status
Item Help
Menu Level
mnlk
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults