Elitegroup G733G - Manual (Page 63)

Remove the compartment cover and then angling it up and out.
If you need to install a higher capacity module, gently push the edge clips on both sides to release the
module. Angle the card slightly upward and gently slide it from its edge connector slot. Store the
card in the anti-static bag that contains your new module(s).
To install the new memory card, hold the card with its gold edge connector toward the edge connector
slot of the compartment. To help you orient the cards, the edge connector has been made with two
unequal-length sections. You will only be able to insert the card in one direction.
Insert the edge connector into the slot. The gold edge connector of the card should not be visible
when the card is fully inserted.
Press the card downward where you should hear an audible click as the latches of the connector
secure the card in place.
Once the module is properly seated, you can replace the cover on this compartment.
Replace and tighten the screw.
Easy to Upgrade HDD Module
The hard drive in your notebook computer is made to be easily swapped out for upgrading. You should
back up your hard drive before attempting o change the hard drive.
Make sure that before you install a new drive, all the files in your system should be backed up.
How to upgrade your Hard Drive
Power down the system completely. Turn the system over with the front of the unit facing you.
Remove the two screws that secure the compartment cover and set them in a safe place.
Slide the HDD cover away from the compartment.
The drive is attached to a special bracket that secures it to the notebook computer. There are 2
screws that hold the bracket.
53