Elitegroup 536 - Manual (Page 64)

4. If you need to install a higher capacity module, gently push the edge
clips on both sides to release the module. Angle the card slightly
upward and gently slide it from its edge connector slot. Store the
card in the anti-static bag that contains your new module(s).
5. To install the new memory card, hold the card with its gold edge
connector toward the edge connector slot of the compartment. To
help you orient the cards, the edge connector has been made with
two unequal-length sections. You will only be able to insert the card
in one direction.
6. Insert the edge connector into the slot. The gold edge connector of
the card should not be visible when the card is fully inserted.
7. Press the card downward where you should hear an audible click as
the latches of the connector secure the card in place.
8. Once the module is properly seated, you can replace the cover on
this compartment.
9. Replace and tighten the screw.
Upgrading your Top Side Memory
56