Elitegroup 536 - Manual (Page 33)

Loading a Disc
To play a CD disc, follow the instructions listed below.
1. Push the CD-ROM/DVD-ROM/Combo eject button on the CD drive
door. Gently pull the tray all the way out.
2. Carefully lift the CD-ROM/DVD-ROM/Combo by the edges and
make sure the shiny surface is face down (the side with no writing on
it). Carefully insert the CD-ROM onto the tray. Push the CD-
ROM/DVD-ROM down gently so that it snaps onto the center ring.
3. Push the tray back into the drive.
To remove a disk, do the following:
1. Check the LED display and make sure that the computer is not
accessing the CD-ROM/DVD-ROM drive.
2. Push the eject button and pull the tray all the way out.
3. Carefully pick up the CD disk by the edges and – while pressing
down on the center ring – remove the CD-ROM/DVD-ROM/Combo
from the tray.
Do not insert any foreign objects into the disc tray. If you experience
difficulty when ejecting the CD disk tray, stretch a paper clip (or use
a pin or a thin metal rod) and insert it into the emergency eject hole
located on the right side of the front panel. The CD disk tray should
eject immediately. This procedure can also be used to remove a CD
from the drive when the Notebook is powered off.
25