American Dryer Corp. MDG-30 - Manual (Page 34)

30
b. Select Temperature
The dryer will start, the light emitting diode (L.E.D.) display will read the temperature cycle selected,
and the drying time portion of the L.E.D. display will read “00” and count upward as time elapses, or the
vended time will count downward, depending on the program parameter setting.
IMPORTANT: If the door is opened during a cycle, both the heat and motor will stop. However, the
microprocessor controller (computer) will continue to count the time, either upward or
downward, depending on which parameter is programmed. Continuation of the cycle
will resume only after the door has been closed and any other of the three (3)
temperature selection buttons is again depressed.
c. Once the preprogrammed dryness level and cool down period has been reached or the maximum
automatic time has expired, whichever comes first, the tone (buzzer) will sound for 5-seconds, and the
L.E.D. display will read “donE,” at which time the dryer will shut off.
NOTES: 1. If the Anti-Wrinkle program is active, the L.E.D. display will continue to read “donE,” and
the microprocessor controller (computer) will proceed through the Anti-Wrinkle program
until the maximum “Active Guard Time” has expired or until the door is opened, whichever
comes first. The L.E.D. display will read “FILL” or “Amount To Start.”
2. If the Anti-Wrinkle program is not active or in use, the L.E.D. display will read “FILL” or
“FrEE.”
4. Non-Microprocessor Controller (Computer) Models
a. Turn power on to the dryer.
b. Insert coins - rotary meter type ONLY.
c. Select temperature by pressing the desired setting.
d. Press “Start” button to start the cycle.
e. Upon completion of the drying and cooling cycles the dryer will shut off.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. Continuation of the
cycle will only resume after the door has been closed, and the “Push To Start” button is
pressed.