Earthway Outlet C22HDS - Manual

P LEASE C ALL IF YOU ARE MISSING ANY PARTS , HAVE ANY DIFFICULTY IN ASSEMBLY , OR HAVE ANY QUESTIONS REGARDING
THE SAFE OPERATION OF THIS SPREADER . T HIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
S UPPORT H OT L INE : 574-848-7491 or 800-294-0671 E MAIL : [email protected]
ASSEMBLY and OPERATING INSTRUCTIONS
EarthWay
E V -N-S PRED
®
C22HD & C22HDS
Broadcast Spreader
HELPFUL HINTS:
If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must
turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller after each use as some
fertilizer may become stuck on the impeller blades and will cause uneven spreading.
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader thoroughly after
each use. Wash between the shut off plate and bottom of the hopper.
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
When using Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily. Rock Salt will
reconstitute back into a solid block over night with humidity and will damage your spreader.
1. Remove and identify all of the loose parts from carton.
2. Position hopper on side. Install frame using (4) #14x 1-1/2” Flat
Head Phillips machine screws.
R OCK S ALT IS NOT RECOMMENDED
FOR USE IN THIS SPREADER .
R EMOVE AGITATOR WHEN USING
I CE M ELT .
Pt# 52153 PAGE 1