Davey PoolSweepa Hybrid - Robotic Suction Pool Cleaner - Manual (Page 9)

Hybrid - Robotic Suction Pool Cleaner | Operating Instructions 7
❙ ❙
Removal from the Pool and Storage
When you choose to remove the
Hybrid Cleaner from the pool:
1 Ensure to switch the pool
pump OFF.
2 Disconnect the Skimmer
Adaptor from the suction line
opening.
3 Disconnect the Safety Valve.
4 Disconnect the Hose Sections,
pulling them slowly one-by-
one out of the pool.
5 When you reach the section
connected to the Hybrid
Cleaner , grasp the Hybrid
Cleaner handle and remove
the Hybrid Cleaner from the
pool (Drawing J).
CAUTION
Remove the Hybrid Cleaner from the pool only by its handle!
6 Store the Hybrid Cleaner and Hose Sections out of
direct sunlight. Do not store the Hybrid Cleaner where
it will be exposed to excessive heat or frost. Make sure
that Hose Sections are in a straight position (Drawing K).
7 For longer life of the equipment, it is recommended to
rinse the
Hybrid Cleaner and parts with tap water.
8 Reopen all skimmers.
❙ ❙
Troubleshooting
The Hybrid Cleaner is designed to operate with a minimum of user maintenance.
If a problem does occur, try to determine the cause. Often, the solution is already part of the
standard operating instructions in this booklet. If you cannot solve the problem easily, contact your
supplier.
K
J
Note: To ensure longevity of your Pool
Cleaner, it is recommended that the
Pool Cleaner is removed from the pool
when not in use, especially at times
when superchlorination is performed.