Davey OZOMATIC OZONE GENERATORS - Manual (Page 11)

11
OZOMATIC ® 24 Hour Circulation Specifications
Power Consumption: Less than 100 Watts
Less than AUD 0.29
Maximum Flow Rate: 37 litres per minute (2,270 litres/hour)
Maximum Head:
7 metres
Maximum Water Temperature: 60˚C
Maximum Pressure: 200 kPa (30psi)
This pump is especially suitable for use with a Mazzei or Mini Footwell Injector. When used with a Mazzei Injector, the
flow rate is approximately 1000 litres/hour dependant on outlet back pressure. Suction from the Mazzei Injector is ideal for
the MOG20 and MOG60 Generators.
8. OZOMATIC
®
INSTALLATIONS BELOW WATER LEVEL:
The Ozomatic ® must be run in conjunction with a 24 hour pump. One non-return valve must be fitted close to the
Injection System and a second non-return valve and “Y” barb connector fitted at the lowest point of the clear tube to
enable any water seepage to drain should a power failure occur. Please make sure non-return valves are fitted in the
correct direction in the line and the Ozomatic
® has the correct air flow rate to maximise the life of the ultra violet bulb
chambers – refer to diagram below:
IMPORTANT: Water entering the Ozomatic
®
is solely due to incorrect installation. Please follow
installation procedures for all applications very carefully.
Warranty is void if water damage is apparent. Refer to warranty card for detailed conditions.