Warnings, Abo ve groun d opt ion, Two types of installation – Davey RAINBANK WITH SUBMERSIBLE PUMP User Manual
Page 5

6
6
1
2
5
1
2
3
In-tank Optio
n
Model No. KRBS1&
2
3
5
6
9
4
7
Above Ground Option
Model No. KRB1,2,3&4
9
4
Mains water supply
900kPa Maximu
m
1
3/4” BSP Male thread
2
3/4” BSP Male thread
3
Pump Power lead
4
RainBank
®
Power lead
5
Stop valv
e
W
arning
:
Do not reconnect with
mains water supply
Important:
All pipework and outle
t
fittings from RainBank
®
must
be labelled to AS/NZS 3500
6
Float switch
7
Manual start button
8
Rainwater supply via pump
9
8
8
32
5
WarnIngs
• before installing your rainbank
®
controller, please read all instructions
carefully as failures caused by
incorrect installation or operation are
not covered by the guarantee. Your
rainbank
®
controller is designed
to handle clean water. the system
should not be used for any other
purpose without specific referral to
Davey. the use of the system to
pump flammable, corrosive and other
materials of a hazardous nature is
specifically excluded.
• WarnIng: Water freezing inside
the rainbank
®
will damage the unit.
locate your rainbank
®
and pump
so that they are not susceptible to
freezing.
• rainbank
®
must be installed and
serviced by a licensed plumber.
• check with your local water authority
on water restrictions when your
rainwater tank is connected to mains
water.
• Do not enter a empty rainwater tank
- they may contain hazardous gases.
• secure all openings to the rainwater
tank to ensure it will not permit access
to children.
abo
Ve groun
D opt
Ion
Mo
Del
no.
krb
1,2,3&4
In
-t
ank
opt
Ion
Mo
Del
no.
krbs
1&2
tWo tYpes oF
InstallatIon
(see page 12)
(see page 14)
!
Installation Inside Buildings: to
cater for possible plumbing leaks or damage
to the rainbank
®
system components, the
installation must include an enclosure that will
capture any water spraying from the plumbing
or rainbank
®
system and direct it into a
properly constructed drain tray.
!
Note: When installing a rainbank
®
and/or associated pump system inside a
building, allowance for possible high pressure
leakage Must be made.
!
Note: In order to carry out routine
maintenance to the rainbank
®
Must be easily
accessible to the end user or home owner.
!
Note: If the supply cord is damaged, it
must be replaced by manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.