Boltek StormTracker-PCI - Manual (Page 9)

TRACKING STORMS 5
The antenna may be mounted with nylon cable ties, or with nylon bolts through the
mounting flanges (available at a hardware store). Do not use steel screws to mount your
antenna, as the antenna must not be near any metal objects.
If mounting the antenna outdoors, care must be taken to protect the antenna connector
from moisture. While the antenna is completely waterproof the antenna connector must
be sheltered from rain. Place the antenna inside a non-metal housing such as a length of
ABS or PVC pipe with an end cap covering the top. Keep a small opening on the bottom
to allow condensation to drain out. ABS or PVC pipe, fittings and glue may be
purchased from a hardware store plumbing department. Mark NORTH on the outside of
the pipe to help in orienting the antenna correctly.
Fasten the cable to the wall or support about 6-12" below the antenna. Leave a bit of
slack in the cable near the antenna so that there is no strain on the connector from the
wire.
If you find the 50' antenna cable provided is not long enough you may purchase a Boltek
extension cable. This allows you to locate the antenna up to 200' from your computer.
You may also purchase a replacement cable at any computer store selling network
hardware. Any Category 5 cable up to 200 feet will work. See Appendix C for
information on making your own antenna cable.