STI UB-2 - Manual (Page 4)

- 4 -
CHANGE TOP MESSAGE
Refer to notes on pg. 2 for “EMERGENCY” message use.
1. Remove LED circuit board.
2. Remove current message by pushing in and down on tabs 1 and 2 with a
small screwdriver. If necessary, also push in and down on tabs 3 and 4.
Once message is loose, remove from the front of the plate.
3. Select new message and snap into place. Blank plates are included to
create your own custom message.
2
1
2
3 4
SCREWDRIVER
UB-1L LED PCB
NYLON WASHER
SELF TAPPING SCREW
1