ReadyLIFT Toyota Sequoia SST Lift Kit: 2001-2007, 2WD & 4WD, 2.5F/1.5"R" - Manual (Page 4)

ReadyLift ® (Part# 69-5010) Installation Instructions
2000-2007 Toyota Sequoia 2WD/4WD
Please read instructions thoroughly and completely before beginning installation.
Check www.Readylift.com for any updated installation instruction.
Installation by a trained mechanic is recommended.
Unbolt the lower panhard bar. Remove the rear coils
and bump stops. Install the ReadyLift rear coil spacers using the M14
hardware supplied. Torque to 95 ft-lb.
13. 14.
Unbolt the upper sway bar end links. Support the rear
axle with a jack. Unbolt the lower rear shocks. Unclip the ABS line at the
various points that need slack as you lower the axle.
11. 12.
Install the rear coils and bump stops, make sure that
the bump stop seats into the coil spacer. Raise the
rear axle and re-install the lower rear shocks. Re-
install the lower panhard bar, upper sway bar end
links, and the brake line support bracket bolts. Re-
connect the ABS line where it was unclipped. Install
the wheels. Double check that all hardware is tight-
ened to factory torque specifications.
15.