ReadyLIFT Toyota Sequoia SST Lift Kit: 2001-2007, 2WD & 4WD, 2.5F/1.5"R" - Manual (Page 3)

ReadyLift ® (Part# 69-5010) Installation Instructions
2000-2007 Toyota Sequoia 2WD/4WD
Please read instructions thoroughly and completely before beginning installation.
Check www.Readylift.com for any updated installation instruction.
Installation by a trained mechanic is recommended.
Re-install the skid plate using the OEM hardware in the
front and the supplied hardware in the back. The 1/2” tall
spacer goes between the frame and the skid plate.
Remove the brake line support bracket bolt located on
the cross member near the fuel tank. Remove the emergency brake line support bracket bolts
located on both the driver and passenger side lower trail-
ing arms and on the frame rail.
7.
10. 9.
8.
Remove the front skid plate and save the OEM hardware.
Support the front differential with a jack and remove the two
differential torque arm bolts. Save the large washer.
Slowly lower the jack to allow the differential to rotate down.
Place the 1” tall steel spacers between the frame and torque
arms. Install the supplied hardware with the large washer.
5. 6.
Remove the rear wheels. Unbolt the brake line support
bracket bolt located on the driver side rear upper trailing
arm.