ReadyLIFT Jeep JK Wrangler, 2007-UP 4 Max Flex Lift Kit" - Manual (Page 6)

www.ReadyLIFT.com - Phone: (800) 549-4620
Installation Instructions 49-6407
6
Install new adjustable track bar and torque down. Also
re-install the tie-rod end and torque down. 25.
Unbolt the brake line and remove from vehicle. Remove old bracket and install
the new Bracket. Bolt the bracket to the frame first, then install the line
through bracket. Finish with the push on clip to hold brake line.
26.
Brake lines are different for a pass. side & driver side, not universal. The bend
goes toward the wheel. Route ABS wire properly. You must bleed
brakes before the vehicle is driven. 27.
Unbolt rear brake line bracket from bottom of the cab. Bolt the
stock bracket to the drop bracket with supplied hardware.
28.
Install new 11” sway bar end links with provide hardware.
Note: Head of bolt must face to the inside of vehicle. 23.
Re-install the front drive shaft to the differential using Lock-
tight. Re-align marks to insure proper drive shaft alignment. 24.
Slip bump pad extension in the coil spring and install as complete assembly. Then
tighten the bump extension bolt down using the hardware provided.
21.
Install new extended length shocks.
(Max Length Shock is 28 inch’s) 22.