Actiontec electronic DataLink V.90 PC Card Fax Modem PCMCIA - Manual (Page 39)

36
6 Troubleshooting
37
Windows 95 OSR2
1. Eject the Modem from the computer
2. Select Start, Settings, Control Panel, then double-click Modems.
3. Click Modem once to highlight, then click Remove.
4. Close the “Control Panel” window and return to the Desktop. Do not
reboot or restart the computer! Select Start, Programs, then MS-DOS
Prompt!
5. The “MS-DOS Prompt” window appears. At the prompt, enter the fol-
lowing commands, exactly as shown ( means press the Enter
key on the keyboard).

Note: If the Windows Directory is not named “C:/Win-
dows,” substitute its new name in the entry below.
cd c:\windows\inf
rename *.inf *.bak
cd c:\windows\inf\other
rename *.inf *.bak
exit
6. The “MS-DOS Prompt” window closes. Do not reboot or restart the
computer! Insert the Modem into the computer and perform the standard
installation procedure (see the “Windows 95” section of chapter 4, “Install-
ing the Driver Software”).
7. After installing the driver software, select Start, Programs, then MS-DOS
Prompt. The “MS-DOS Prompt” window reappears. At the prompt, enter
the following commands, exactly as shown.
cd c:\windows\inf
rename *.bak *.inf
cd c:\windows\inf\other
rename *.bak *.inf
exit
The Modem and computer are now properly configured and ready to use.