Sterling RT - Manual

Roof Curb Kit Model No. ____________________
ROOF CURB KIT INSTALLATION INSTRUCTIONS
For Packaged Rooftop Arrangements
RKM-2
J30-03369
ATTENTION
Read these instructions carefully prior to installing this equipment.
Check all specifications and make sure the appropriate equipment is being installed.
Record the Model number in the space provided. Retain this manual for future reference!
Improper installation, adjustment, alteration, service or maintenance can cause property
damage, injury or death. Read the installation instructions thoroughly before installing or servicing this
equipment.
RECEIVING INSTRUCTIONS
Inspect the shipment immediately when received to determine if any damage has occurred to the unit dur-
ing shipment. After the Roof Curb Kit(s) have been unpacked, check for any visible damage to the parts. If
any damage is found, the consignee should sign the bill of lading indicating such damage and immediately
file claim for the damage with the transportation company.
05/07
INSTALLER’S RESPONSIBILITY
Installer Please Note: This equipment has been inspected and shipped free from defects from our factory.
Inspect all parts required for each roofcurb kit and ensure all parts are accounted for. It is the installer’s
responsibility to inspect and correct any problems that may be found.
The following terms are used throughout this manual to
bring attention to the presence of potential hazards or to
important information concerning the product:
Indicates an imminently hazardous
situation which, if not avoided, will result in death,
serious injury or substantial property damage
Indicates an imminently hazardous
situation which, if not avoided, could result in
serious injury or substantial property damage.
Indicates an imminently hazardous
situation which, if not avoided, could result in death,
serious injury or substantial property damage.
NOTICE: Used to notify of special instructions on
installation, operation or maintenance which are
important to equipment but not related to personal
injury hazards.
TABLE OF CONTENTS
I. RECEIVING
Pre-Installation Instructions . . . . . . . . . . . . . . . . .Cover
II. INSTALLATION
*(U)RC001, (U)RC002,
(U)RC003, (U)RC004, (U)RC006 . . . . . . . . . . .2-6, 24
(U)RC005, (U)RC007, (U)RC008,
(U)RC009, (U)RC010 . . . . . . . . . . . . . . . . . . .7-11, 24
(U)RC011, (U)RC012 . . . . . . . . . . . . . . . . . .12-16, 24
(U)RC013 . . . . . . . . . . . . . . . . . . . . . . . . . . . .17-21, 24
Evaporative Cooler Platform . . . . . . . . . . . . . . . .22-23
*(U) indicates that the roof curb kit is shipped from the
factory uninsulated.
Unless otherwise specified, the following conversions
may be used for calculating SI measurements:
1 foot = 0.305 m
1 inch = 25.4 mm
1 psig = 6.894 kPa
1 pound = 0.435 kg
1 gallon = 3.785 L
1 cubic foot = 0.028 m
3
1 inch water column = 0.24 kPa
1000 Btu per hour = 0.293 kW
1000 Btu/Cu. Ft. = 37.5 MJ/m
3
liter/second = CFM x 0.472
meter/second = FPM ч 196.8